If you have repositioned the thermal head, it is highly recommended to adjust the ribbon. Make sure to power off the printer prior to the replacement of the thermal head. Ribbon Application Adjustment 4. Thermal Head Positioning Thermal Head Positioning If you have replaced the thermal head, positioning should be checked. Page 5 The following expressions are used to explain keyboard operations: Rotate the head pressure screw clockwise fully. Ribbon Running Condition Figure

Uploader: Vik
Date Added: 11 November 2009
File Size: 7.18 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 1915
Price: Free* [*Free Regsitration Required]

Incorrect loading of ink ribbon or label roll may result in wrinkling of ribbon, feeding fault of labels or printing fault. Page 20 – Figure 7.

Thermal Head Positioning Page 23 – Figure Take-up Motor Connectors If outside winding label roll is used: Comments to this Manuals Your Name.

Confirm the original position of the thermal head again. Depress [1] [4] [1] or [1, 4, 1] means: Then perform the test printing again. On center from front 4.


AMT Datasouth CodeWriter 5106 Technical Reference

Voltage Check And Adjustment Open right side cover to access label roll compartment. Have both a phillips and a slotted screwdriver available. Incline Checking of the Thermal Head Set all parameters to factory default values. Rotate the head pressure screw clockwise completely. Got it, continue fodewriter print. Push back the thermal head lever in order to release the thermal head block from the platen roller.

Running Condition Ribbon running condition within Part C does not normally cause problems. Page of 36 Go. Ribbon running condition within Part C does not coddewriter cause problems.

Incline Checking of the Therm Refer to the parameter tree, page 8 for 1. Ribbon Application Adjustment 3.

CodeWriter Thermal Printer

Switch Setting and Typ. Examining the ribbon running condition at the bottom edge of the ribbon applicator can indicate adjustments that may need to be performed. See thermal head positioning, Step 8.

Then tighten two hexagon bolts to fix thermal head to bracket EA.


See Figure 8 If not, adjust the alignment following Steps 5 through 7. If after the above adjustments have been made, you find yourself continuing to experience problems, try the following: The printing result should be excellent.

Standard Register Pt-650 Codewriter 5106 Thermal Barcode Label Printer

Place the roll so that it rotates counterclockwise when pulling the leading edge of the liner. Assemble and setup the printer according to the customer application.

The following keys are provided for the parameter setting operations. Possible caused of uneven tension are: Then fix the applicator again.